Industrial metal stairs

OSHA Regulations for Industrial Metal Stairs

CTA for Expert quote from Upside Innovations

Call (513) 889-2492

OSHA regulates every factor about a workplace, and below you will find the code that we follow for our fixed, industrial stairs.

osha stairs labeled

Landings, Platforms & Catwalks

Platforms and catwalks can be placed at the top, middle, or bottom of a set of metal stairs.

  • Width:  Platforms must be at least the width of the stairs. (1910.25(b)(4))
  • Depth: Platforms must be at least 30 inches deep, as measured in the direction of travel. (1910.25(b)(4))
  • Door or gate present: The door or gate must open up onto a platform, and the swing of the door does not reduce the platform’s depth to 1) less than 20 inches for platforms installed before January 17, 2017 or 2) less than 22 inches for platforms installed on or after January 17, 2017. (1910.25(b)(5)(i) & 1910.25(b)(5)(ii))
OSHA compliance stairs platforms

Guardrails & Midrails

As an employer, there is a duty to have a fall-protection system in place when there is an unprotected edge that is 4 or more feet from a lower level; guardrails are the most common fall-protection system used for stairs.

  • Step Guardrail Height: Unlike ADA guidelines, the guardrails in OSHA steps also act as handrails when the top edge of the guardrail is between 36 and 38 inches above the leading edge of the stair tread. (1910.29(f)(1)(iii)(A))
  • Platform Guardrail Height: The top edge of the top guardrail must be 42 inches, plus or minus 3 inches, above the walking surface, measured vertically from the step tread. (1910.29(b)(1))
  • Platform Midrail Height: A system must be put between the steps and the top guardrail to prevent an employee from falling through. Midrails are commonly used in conjunction with the top guard rail. The midrail must be installed at a height midway between the top edge of the guardrail and the walking surface. (1910.29(b)(2))

Step Treads

The step tread is the part of the stairs that you walk on. It can be made from a multitude of decking materials that offer various degrees of traction.

  • Tread depths must be the same between each landing platform. (1910.25(b)(3))
  • The minimum tread depth is 9.5 inches. (1910.25(c)(3))
  • The minimum tread width is 22 inches between the stringers. (1910.25(c)(4))

Risers

Risers make up the vertical area between step treads. Risers can be solid or open-back, depending on the required compliance code. OSHA does not require solid risers, so most companies choose to have open-back risers because that style is typically less expensive.

  • Riser heights must be the same between each landing platform. (1910.25(b)(3))
  • The maximum riser height is 9.5 inches. (1910.25(c)(2))

Footplates

Footplates are bolted into the ground to secure the stair system.


Sources: OSHA regulations for fixed, industrial stairs: 1910.25 & 1910.29

Our Services

Our team designs, manufactures, ships, and installs ADA & IBC-compliant stairs, ramps, and canopies to fit YOUR custom project. Our experts will work with you throughout the project to ensure your installation is correct to your specifications and code-compliant.

Design Version 2Next serviceManufacture V2 GraphicNext serviceShip Icon V2Next serviceInstall Version 2
Membership Affiliations: